1. Eterlogic Virtual Serial Port Emulator Pc
2. Eterlogic Virtual Serial Port Emulator Free
3. Vspe Virtual Serial Port Emulator

The example below shows how to create Virtual COM Port Pair (COM10COM11) using. Download and install ( VSPE ). Start VSPE program. On the Device menu, click Create. In the Device type field select Pair. Then click button.

Select Virtual serial port 1 (COM10) and Virtual serial port 2 (COM11). Click button. Verify that the ports COM10 and COM11 have been successfully installed. To save configuration file on the File menu, click Save as.

Remember config file location (for example it can be c: config.vspe ). Virtual ports COM10 and COM11 are connected with each other via virtual Null-modem cable. You can use them to operate with Fax Voip modem line. To run the emulation manually, just click on the configuration file ( c: config.vspe ) in Windows Explorer. Notes. is not started by default during system startup.

Eterlogic Virtual Serial Port Emulator Pc

Therefore, you need to pay special attention to configure the emulator to run automatically at startup. You can in the Windows Startup folder,. Corel products keygen xforce.

Eterlogic Virtual Serial Port Emulator Free

Just beware of the Hamlib TS480 library for PTT, it has a race condition where the order of the replies from the DUO can cause lockups. Stick to using serial port PTT and the problem goes away.

We need some brave soul to write an official Hamlib library entry for the DUO, without the bugs of the TS480 version. I send the output of VRX1 to VAC and then point the input of all the various programs at that VAC stream. I avoid the serial port contention issue by only using one program at a time to send CAT commands, but if you want to have multiple programs able to control SW2 and/or DUO at the same time, you will need to handle port contention (or use separate virtual ports) as recommended. On 14:41, Bob W0EG wrote: Thanks.

Vspe Virtual Serial Port Emulator

I see now that setting FLDigi sound card Port Audio to 'Line (FDM-DUP Audio v1.04)' gets the audio stream from the stand alone DUO. The DUO must be started first, then open FLDigi. I did need to increase the gain a bit on the DUO to get equivalent levels as compared to my TS-590S. However, I should have been more specific in my question.

I was referring to using the FDM SW2 software and sending its output to the decoders. I read this app note from Elad: ELAD Application Notes AN-­‐002 rev 1.0 Setting FDM-­‐SW2 with external programs: CW Skimmer, FLDI This is where they say to use the recommended port emulator and set the second and the receivers in SW2 to different ports. I have not yet tried transmitting PSK on the DUO but that will be be my next step and I will need to enable CAT. I'll try looking for a RigCat file for the DUO like the one that works so well in FLDigi with the TS590S.